killofree.blogg.se - Installing front license plate holder nissan versa

#Installing front license plate holder nissan versa how to#
#Installing front license plate holder nissan versa series#

From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever delicately on all the frame of the trunk to remove it.

Identify the position of your light bulbs from the outside.

Unplug the battery from your Nissan Versa.

In this case, here is the process to perform this task:

#Installing front license plate holder nissan versa how to#

How to replace the rear license plate bulb on my Nissan Versaįinally last possibility, you must replace the bulb on the backplate of your Nissan Versa, but you cannot open the cover from the outside of your vehicle.

To replace the one on the front plate, nothing could be much easier, you will have to put yourself under the vehicle (preferably positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general held by two soft plastic tabs by pressing on both at the same time, then now that you have your license plate bulb block in hand, Take away the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be attentive not to put in too much pressure otherwise you will break the plastic cover), and you will only have to take off the burnt-out license plate bulb and swap it with the new, then test out and reassemble the whole thing. How to replace the front license plate bulb on my Nissan Versa

#Installing front license plate holder nissan versa series#

Most often you will be able to access it, however some series (often at the rear does not allow this access). Second section of our article, change this license plate bulb on your Nissan Versa without external access. How to change the number plate bulb on your Nissan Versa without outside access Last step, before reassembling, reconnect your battery and verify the light to validate the successfulness of the process.Finally, put the new license plate light bulb.Use your screwdriver or knife to eject the bulb from its placement, if you are worried of breaking something, you can also do it with your fingers.Face your license plate and use a flat screwdriver or knife to place the flat part into the notch provided for this intent (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Nissan Versa.

With the engine off, disconnect the battery terminals from your car.Here are a few simple actions to stick to to execute this service: Regardless whether it’s the front or the back of your vehicle the operation will be identical. So let’s start with changing the number plate bulb by going through the outside of your Nissan Versa. Regrettably on some years or packages of car these covers do not open from the outside and if this is the case we will take a moment on in the second section of this article to demonstrate the approach. This approach is the least difficult of the two, in fact, for this one you will only have to take off the protective covers of the bulbs.